From us! Right here on the site.

Right here!

Right here!

Just black and white at this time.

You can try with Cardinal Paint (the same brand we use for powdercoating)

• Black
• White

The booth is made of aluminum. The top is PVC (unless you choose to upgrade to plexiglass or star board).

55 lbs (with no gear inside)

Yes, in less than 5 minutes and goes into two heavy duty carry bags.

The bag for the top and laptop stand is approximately 48" x 7" x 25" and the bag for the rack and base plate is approximately 33" x 11" x 20”.

See the diagrams here.

No. However, we have had DJs over 6' behind the booth very comfortably.

The booth is assembled with quick latches. The controller or turntable leveling system uses thumb screws and allen screws. (Allen keys are included)

Normal sized controllers (Pioneer DDJ1000, FLX10) can ride in the top with some modification. Gear can stay in the rack. We don’t recommend leaving heavier controllers (Rane One, Pioneer Rev7) inside. We recommend using a Decksaver over your controllers.

Yes, if you stand it up vertically.

Yes, you can adjust the tilt and how far the “plate” moves forward or back. It can also go in the left, right or middle of booth. If it is still not close enough to you, order the deluxe stand from us.

There is a small decal on the DJ's side by your waist.

The booth can possibly be fixed by your local body shop or dent remover shop using a specific set of tools. Here's an example.

Yes, there is a slim threaded "rail" behind the holes in our rack.

12

Visit the Bunn Gear Fans Facebook Page or Bunn Gear Instagram to see mods.

Yes, as long as they have a threaded bottom on them. Our stands have a 1/4” nub which fit Both Lighting 360 Tubes, GloTubes and other brands. If you have something else, simply choose the correct adapter at checkout.